Contents
- Product Page
Custom Settings
Custom Settings are used on the rare occasion when the default settings do not properly process a file, or when increased speed is needed in processing. By default Barcode Batch Separator will search the entire page, with custom settings it can be configured for a specific area to be searched.
Click on "Custom Settings"
To setup the Custom Settings, begin by clicking on "Load File" (1) and then browse to and select the cover page. The Cover Page barcode must contain "SEPARATOR" only.
Once the Cover Page is loaded, click on "AutoSize" (2) to view the entire page.
Once the barcode can be seen, left click on the top left corner of the barcode and drag the mouse to the bottom right to highlight the barcode (3). This will set the area to be read. Since scanners do not always align the paper exactly it is a good idea to include an area larger than the barcode.
When the area is selected if necessary the page rotation can be set (4)
The confidence level (5) determines what percentage of passes are to be correct when reading the barcode. Good accuracy will be had in the 70 - 80 range. Please note is virtually impossible to get 100 percent even if the file was created with an image printer.
Adjust the Contrast Level (6) of the file if necessary.
Click on Test (7) and check the results in (8). If it says SEPARATOR it is setup correctly.
Repeat the process testing different settings if necessary until SEPARATOR is read.
If a barcode other than a Code 39 " Code 3 of 9" is being read, set the type in box (9).
When the barcode is properly read, click on "Add Region" and then save.
When saving the settings it must be saved in the folder "C:\Program Files\edocfile\Barcode Separator" with the file name of custom.ini